Harley Davidson Exhaust Bolt Torque

Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. Rear Intake is Blue. Front Exhaust is Green.

harley davidson engine heat shields harley davidson engine working harley davidson engine oil flush harley davidson engine rebuild cost harley davidson engine mounts harley davidson engine management light harley davidson engine parts diagram harley davidson engine number location

Torque Specs For Exhaust Studs Harley Davidson Forums

Exhaust Header Torque Settings Harley Davidson Forums

Need Some Torque Specs Harley Davidson Forums

Torque Specifications Motorcycle Powersports News

Vance And Hines Eliminators Torque Specs Harley Davidson Forums

2016 Harley Davidson Street Glide Torque Specs

My service manual says to use NEW torx screws to remount the front brake disc rotors and tighten 16 to 24 FOOT lbs.

Harley davidson exhaust bolt torque. Then remove the rear exhaust pipe mounting bolts. I would tighten the TORCA clamps to 45-60 ft-lbs. Today Doc Harley explains the importance of checking the torque on your exhaust bracket boltsharleydavidson torque motorcycles.

Torque the cylinder stud nuts to 60 to 80 inch-pounds using a torque wrench. Tighten each bolt to 12-15 foot pounds of torque. I always check the torque values after everything is bolted up too.

The nfieldgear catalog says the correct torque is 4 ftlbs 48 inlbs. Im going to fit a Muscle exhaust to my 07 DX and dont want to crush anything - I only have the settings for the older style exhaust seals - they may have changed. Step 6 Raise the exhaust pipes back up and thread the head bolts and rear mounting bolts into position.

Harley Davidson Dyna 2006 - Current 2 into 1 HK-DY2-1 Installation Instructions HARLEY DAVIDSON 2006 - 2013. 10 - 22 in. Harleys head-bolt torque method harkens back to a time when torque specifications were less scientific.

Axle nut is set at 50 FOOT lbs. Exhaust bolt torque spec. If you are referring to the cylinder head exhaust flange --- tighten the top nut of the front head to 9-18 in-lbs then tighten the lower nut to 120 in-lbs finally tighten the top nut to 120 in-lbs.

Locate the flangeor flat rimon both the torque cones and the exhaust. Additionally tighten the head pipe support bracket bolts as indicated in the exhaust manufacturers instructions. Gaskets are soft and can squish into the port area if tightened too much.