Harley Davidson Exhaust Flange Nut Torque
Rode to work and retorque.
Harley davidson exhaust flange nut torque. Expert Gear Advice From Riders. Ad Fast Free Shipping on Orders Over 40. Remove the clamp bolt which mounts the rear head pipe to the belt drive cover bracket.
About 4 days of riding. Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. Def think it needs a couple iterations of torque.
20Install front Heat Shield tighten back clamp first then tighten the clamp by head. Tighten the exhaust into place. Repeat these steps for the rear cylinder head exhaust flange.
Fastener Size - Torque ft. Harley Davidson 65184-02-7593 Exhaust Flanges Nuts Torque Cones fits model. Pump - Twin gerotor dual scavenge crank mounted and driven internal oil pump dry sump Pressure - 30-38 psi 207-262 kNm 2 at 2000 rpm and normal operating temperature of 230o F 110o C Rocker Arm IN.
See figures 3 4 and 5 for clamp orientation. Dyna Sportster Softail Touring. 14 - 10 ft.
It was about 300 miles after the exhaust install. The torque values I found for that size thread gives 8 ftlbs for a steel to steel interface. HARLEY -DAVIDSON Manufacturer Part Number.